Add Product

Search Results:

Reply
Visitor
Posts: 1
Registered: ‎01-25-2015

24" LED TV - Forced to do a channel scan every time I turn tv on.

I recently tried using a digital antenna with a coaxial input to the insignia TV and was only able to get a few channels.
I then decided to switch back to using my cable box using the same coaxial TV input.
I ran the auto-channel scan as instructed and everything went back to normal with all my cable channels in place.
The problem arises when I turn the TV off and back on again. It fails to find a signal.
The input is set correctly, but it forces me to go through the Channel Scan again. 
I tried unplugging the TV and my cable box and starting over, but I get the same results. 

 

 

Visitor
Posts: 1,511
Registered: ‎07-21-2014

Re: 24" LED TV - Forced to do a channel scan every time I turn tv on.

Hello dcanfield7,

Welcome to Community@ Insignia™!

Try just keying in 03 on the remote, and see if that will allow lock onto the signal from the cable box. What is the model # for the TV, it should start with a NS-.

Regards,
Jon
Insignia™ Support