12-24-2008 10:02 PM
I recently purchased these and hooked them with HDMI cables(from HD sat reciever to Yamaha RX-V463 out to Sony Bravia 46" KDL-40Z4100). Problem is that I cannot override the reciever and listen to the TV speakers. Also, I cannot get the Rx-V463 info to display on the TV. Any suggestions?
Solved! Go to Solution.
12-26-2008 05:04 PM
Problem is that I cannot override the reciever and listen to the TV speakers
On page 14 of you manual it says, "
2-channel as well as multi-channel PCM, Dolby Digital and
DTS signals input at the HDMI IN DVD or HDMI IN DTV/
CBL jack can be output at the HDMI OUT jack only when
“SUPPORT AUDIO” is set to “Other” (see page 67).
Page 67 says,
HDMI set H)HDMI SET
Use this feature to select the component to play back
HDMI audio signals.
Support audio S.AUDIO
Use this feature to select whether to play back HDMI
audio signals on this unit or on another HDMI component
connected to the HDMI OUT jack on the rear panel of this
• This unit transmits audio and video signals input at the HDMI
input jacks to the HDMI out jack only when this unit is turned
on even if “SUPPORT AUDIO” is set to “Other”.
• Available audio/video signals depend on the specification of the
connected video monitor. Refer to the instruction manual of
each connected component.
Also, I cannot get the Rx-V463 info to display on the TV. Any suggestions?
page 15 suggests:
Some video monitors connected to this unit via a DVI
connection fail to recognize the HDMI audio/video signals
being input if they are in the standby mode. In this case, the
HDMI indicator flashes irregularly.
• When you connect your TV monitor or projector via HDMI
connection, the OSD does not appear. In such cases, connect the
TV monitor or projector via component, or video connection
Hope this helps. I found this info in about 10 minutes while looking at your manual at http://www.4electronicwarehouse.com/content/yamaha/rx-v463-u-man.pdf