1. Install
supplied headphone rechargeable AA batteries:
a. With
the earpiece cushion facing you, unlock and remove the cushions by slightly
rotating the left cushion clockwise and the right cushion counterclockwise,
then pulling them away from the headphones.
b. Insert
one AA rechargeable battery into each battery compartment. Make sure to align
the + and – symbols on the batteries with the symbols in the battery
compartments.
c. Put
the left and right cushions back into place.
Note:
Before using the
wireless headphones for the first time, make sure the batteries are fully
charged for at least 16 hours. This will provide a longer operating lifetime
for the batteries. For more information on charging your headphones refer to Question 10
on page 5.
2. Connect
the docking station to your audio source (i.e., A/V receiver, MP3 player, etc.):
o Using
the supplied RCA audio cable, connect the audio output jacks of your audio
source to the AUX INPUT jacks of the
docking station. Match white to white and red to red.
o Note: If your audio
source only has a 3.5mm “phones” or “line out” jack, use the supplied
3.5mm-to-RCA adapter cable.
3. Connect
the AC adapter to the docking station:
a. Connect
the AC adapter connector to the docking station’s DC IN jack.
b. Connect
the AC adapter plug to an AC power outlet. The STANDBY indicator lights red
steadily when the docking station is set to disable hub status and blinks red slowly
when the docking station is set to enable hub status.
4. Turn
on your system:
a.
Slide the POWER switch on the left earpiece of headphones to ON.
§ The
power indicator lights steadily blue.
Note: If the power indicator does not light
steadily blue see Question 7
on page 4 for more information about the
headphone power indicator.
b.
If this is your only Rocketboost
wireless product, slide the HUB switch
on the docking station to ENABLE.
(If you have other Rocketboost products, only one device in your network can
have the HUB switch set to ENABLE, see Question 4
on page 3 for further information.)
c.
Press the POWER button on the docking station.
§ The
power indicator lights steadily green.
Note: The headphones and docking station
were paired at the factory. When an active link is established between them or
with another Rocketboost device, the power indicator on the headphones and
docking station both light steadily.
o
If the power indicators on the
headphones and docking station continue to blink after 30 seconds, they are no
longer connected to each other. For more information on establishing a connection
between the docking station or another hub and the headphones refer to Question 3
on page 2 or Question 4
on page 3.
