Insignia Connect

[DavidRees]

After creating a Speaker Pair with two NS-CSPGASP speakers (using instructions at {removed per forum guidelines}), the 2nd speaker always shows "SEt" rather than the time. Does anyone have a resolution for that?

d

[DavidRees]

Both devices are firmware 310 and Cast firmware 1.32.129357.

[DavidRees]

Also, speaker model is NS-CSPGASP2 (larger, portable one).

[Sam-BBY Retired: Social Media Specialist]

Hey DavidRees,

Welcome to our community.  I'd love to have two of these speakers set up for surround sound in my room, and I'm sure you're anxious to get ready setting yours up, too.

I'd first recommend trying to turn your speaker off, disconnecting it from your Google Home app, and then trying to set it up again after plugging it back in.  If that doesn't do the trick, you can try performing a factory reset by holding the Microphone button down for 12 seconds.  Then, set the speaker into pairing mode by pressing the – and + volume buttons at the same time for about four seconds until the display shows "BT".

Let me know if this helps!

[AllenRobberson]

I have tried all the solutions and theyu do not work. still says set on the second unit.

[Powel]

I have I same issue, seems to be no solution

[Powel]

I just had to upgrade my modem and the time returned the the second speaker, then this morning it is back to SET. I guess it means it's part of a set 😁

[tonyb53218]

I am having the same issue.  Is there any solution?  We have the speakers in our bedroom and would really like both of them to display the time.

[Powel]

I did find a work around but there will be no clock display on the 2nd speaker. Seperate the speakers, you will have to partially setup the second speaker again (probably why the time will not display when paired) Mute the microphone on the first speaker then "Hey google turn off display" the second speaker should go dark.Now create the speaker pair and turn the first speaker microphone back on.

You will only have one speaker with the clock display but its better than "SET"

[p1eric]

I'm also having this problem. I have two NS-CSPGASP-G speakers on bedside tables. Both are System firmware 310 and Cast firmware 1.32.129357. I've tried factory resetting both, setting each up separately and then setting them as a pair but one of them still shows "set" instead of the clock. Since both are used as alarm clocks the work around to turn off the display isn't an option.

It's a shame because they sound really good when paired. Hopefully we'll get a fix for this soon.