Mobile Audio Systems & GPS

[locomedic1]

I replaced my wifes 99 Explorer original factory radio with a Kenwood single DIN radio...after testing it out it all appeared fine until i went to get out of the truck ,pulled the keys out of ignition and opened the door a warning bell kept going off...the "running" lights are on constantly now...the only way to turn them off is to unplug the set of wires to the new radio....note- the original factory radio had two sets of cable "wire plugs" but the Kenwood only has one set...any suggestions?

[autotech796]

you have to make sure all the connections are all fine.  go back through and test your connections with a DMM, otherwise swing it into your local best buy to have it professionally installed, so that no further damage will be done to the vehicle.